6-24
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Commands
cnffltset
cnffltset
Configure Filter Set—modifies an ATM address filter set.
Use cnffltset to modify an existing filter set. This command can:
•Add more addresses to the filt er s et .
•Change the access mode or address field of a filter set entry.
After a filter is modified for a speci fic port, associate the filter to that p or t by usi ng cnf-pnportacc.
Cards on Which This Command Runs
PXM45
Syntax
cnffltset < name >
[-address atm-address -length address-length [-plan {nsap | e164}]
[-list {calling | called}]]
[-index number]
[-accessMode {permit | deny}]
Syntax Description
name A name for the filter set : the maximum is 30 cha ra cte rs.
address The 1-40 digit NSAP or 1-15 digit E.164 address. You can add the address to a filter
set. The default is mod ifying the accessMod e field of a filter element using t he index
only: in this case, the you need not specify the address field.
length If the address is specified, the length must be specified.
•For NSAP, the length is in bits.
•For E164, the length is in bytes.
plan Address Plan: e.164 or nsap. You may specify this field only if you also specify the
address field.
Default= nsap
list Address List: calling or called. You may specify this field only if you also specify
the address field.
Default= call ing
index Order in which filters are set.
Range: 1–65535
Default= 1
AccessMode Specify the access mode (permit or de ny) to whether accept or deny the call on the
port if the address pattern-mat ch in g suc ceed s .
Default= permit