5-12
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter5 PNNI Commands
addpnni-summary-addr
addpnni-summary-addr
Add PNNI Summary Address—create a PNNI summary address to specify a range of addresses.
The addpnni-summary-addr command lets you create a summary address f or a logical node. The resu lt
of this operation is a range of ad dr esse s. The controller uses this summ ar y t o a cce pt o r r ej ec t ca ll s that
arrive at an address within the address ran ge. Using a summary address decr eases both the provisioning
time and the call setup time for an address within the range.
Cards on Which This Command Runs
PXM45
Syntax
addpnni-summary-addr <node-index> <address-prefix> <prefix-length>
[-type {internal | exterior}]
[-suppress {true | false}]
Syntax Description
The defaults for address prefixes and the peer group ID share values with the ATM address. If you
change the peer group ID (-pgId) you should change the corresponding fields in the PNNI summary
address. (See Figure 5-5.)
Figure5-5 Cisco Factory-shipped Defaults for PNNI Peer Group Identifier, PNNI Summary Address,
ATM Address, and PNNI Node Identifier
47
1
11
# of
Bytes 21
Default PNNI
peer group identifier
136 6
ATM
address
format
0056 160 91 81 00 00 00 XX XX XX XX XX XX XX XX XX XX XX XX 00
53346
Cisco
ICD MAC address MAC address
ATM
address
length
PNNI
hierarchy
level
Default PNNI
summary address
Default ATM address
Default PNNI
node identifier