9-88
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter9 Troubleshooting Commands
dspconinfo
dspconinfo
Display Summaries of Connection Information—display general information about SPVCs.
The dspconinfo runs on the PXM45 and lists the total number SPVCs on each PNNI port on the node.
the default is all ports on the no d e, bu t yo u can a ls o sp eci fy a p a rtic ular PNNI port. For each port, t h e
display shows:
•Number of active connections
•Number of failed connections
•Number of administratively inactive (or d own) co nn ec ti on s a s a r es u lt o f dncon
•Number of alarm indication (AIS) failures
•Number of A-bit failures
•Total number of connections
Note that dspconinfo checks for the down state at the master end o f th e co nn ec tio n ( s tat us at the slave
endpoint is failed). See also the descriptions for dncon and dspcon.
Cards on Which This Command Runs
PXM45
Syntax
dspconinfo
[-port portid]
Syntax Description
Related Commands
none
Attributes
-port Specifies a particular port for the connections. The default for this co m ma nd is all
ports (portid not specified) You can specify a particular port by using the port
keyword followed by the p o rt I D in the following form at :
[shelf.]slot[:subslot].port[:subport]
Currently, the value for shelf is 0 and so is not necessary.
Log: no log State: active, standby Privilege: ANYUSER