9-60
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter9 Troubleshooting Commands
dspcd
dspcd
Display Card
Display the following info r m at io n about a card:
•Hardware serial number.
•Firmware revision level. (See the loadrev description for an explanation of how to interpret the
revision filed.) If a c a rd has no firmware, the d is p lay shows a version nu mb er of 0.0.0.
•Status, possibly including the reason for the last reset (FunctionModuleResetReason) and state of
the integrated alarm (cardIntegrate dAl a rm ) .
•For a service module only, a count of configured lines, ports, and connections.
Note The connection count includes control V Cs when you execute dspcd on the CLI of a service module.
However, when you execute dspcd or dsppnport(s) on the CLI of the controller card, the display
does not include control VCs.
•For a service module only: which physical lines constitute a port group and the maximum number
of connections in that port group. A port group consists of one to many physical lines. This
maximum connection count is a function of the hardware interface type (OC-3, OC-12, and so on).
The port group information also shows the number of existing SVCs, SPVCs, and SPVPs.
Use the maximum number of supported connections to help you configure resource partitions. If a
particular resource partition has close to the maximum supported by hardware on a line, few or no
connections would be possible in another partition on the same line.
Some of the information that dspcd shows is common to the version command, but version shows t he
boot code version in bold.
Cards on Which This Command Runs
PXM45, AXSM
Syntax
dspcd
Syntax Description
This command does not take parameter s.
Related Commands
dspcds, version
Attributes
Log: no log State: active, standby Privilege: ANYUSER