6-100
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Commands
dsppnsysaddr
dsppnsysaddr
Display PNNI Port System Addresses—displays the PNNI system address table.
The dsppnsysaddr command displays addresses in the system address table. The system address table
only contains static addresses.
Note This command does not belong to th e RA mo dul e.
Cards on Which This Command Runs
PXM45
Syntax
dsppnsysaddr
[ ilmi | uni | static | host | all ]
Syntax Description
Display Contents
The ATM address, the address prefixes, and the peer gro up identifier share some default field values, a s
shown in Figure 6-2.
The following parameters are displayed for each node.
ilmi Display all of the ilmi ad dr es se s in the peer group.
uni Display all of the uni addresses in the peer group.
static Display all of the static addresses in the peer group.
host Display all of the host addresses in the peer group.
all Display all of the ad d re sses. This is the default .
ATM Address
(displayed but not
labeled)
Display the PNNI node ATM address. This is a 20-byte, formatted hexadecimal
string. Like all PNNI addresses, identifiers, and prefixes, this value is portrayed
as a string of hexadecimal “nibbles.” One or several pairs of nibbles entail each
parameter field.
Default: Figure6-2 shows the factory-set default.
Type Display the type of address that you specified in the command line.
Range: ilmi, uni, static, hos t
Port id The PNNI logical port identifier.
Range: 1–2147483648