Cisco Systems Cisco MGX 8850 cnfpnportsig

6-41
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Com m ands cnfpnportsig
cnfpnportsig
Configure Port Signaling—specify ATM signaling parameters on a PNNI port.
Before you can execute cnfpnportsig, the port must be down (by dnpnport). For a UNI or an NNI, the
type of interface you specify o n th e c on tr o ll er mu st match the interface type th at yo u co nfigu r e o n th e
slave (the service module). On the service module, you need specify UNI, NNI, or VNNI, but the
cnfpnportsig command has options for spe cifying the version of an inte rface type and other parameters
that apply to signaling. See th e Sy n tax D es c r ip tio n .
Cards on Which This Command Runs
PXM45
Syntax
cnfpnportsig <portid>
[-univer {uni30 | uni31 none}]
[-nniver {iisp30 | iisp31 | pnni10 | enni}]
[-unitype {public | private}]
[-addrplan {both | aesa | e164}]
[-side {user | network}]
[-vpi <vpi>]
[-sigvci signalling-vci]
[-rccvci routing-vci]
[-cntlvc {ip}]
Syntax Description
portid The portid is the PNNI physical port. Th e f o rm at is
[shelf.]slot[:subslot].port[:subport]. See also PNNI Format, page 6-4.
-univer The UNI version: uni30, uni31, none. Note that univer and nniver are mutually
exclusive—so th e i nt er fac e a t e ach end of the connection mus t h ave th e s ame
interface type. Also, the port type on the PNN I con tr o lle r must be the same as on the
slave (through addport ... ifType on the AXSM, for example).
The default for this parameter is UNI 3. 1. If this version is sufficient, you can forego
this parameter. Howe ve r, to change a UNI version, the port mus t be do w n. Re member
to up the port by using th e uppnport co mm a nd after completing the cnfpnportsig
command.
The none choice applies to any port that does not need to run SSCOP protocol (for
example, SPVC endpoints).
Default: uni31