Cisco Systems Cisco MGX 8850 manual cnfsig

6-45
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Com m ands cnfsig
cnfsig
Configure Signaling—configures signaling timers and crankback attempts for a port.
The cnfsig command lets you configure signaling timers for a port whether the port is up or down. The
new configuration applies to n ew incoming calls while existin g calls remain intact. In a dd it ion to
standard timers, this command lets specify the maximum number of crankbacks that PNNI can attempt
at a port. You must specify at least one of the optional parameters.
Cards on Which This Command Runs
PXM45
Syntax
cnfsig <portid>
[-t301 t301-timer ]
[-t303 t303-timer ]
[-t308 t308-timer ]
[-t310 t310-timer ]
[-t316 t316-timer ]
[-t317 t317-timer ]
[-t322 t322-timer ]
[-t397 t397-timer ]
[-t398 t398-timer ]
[-t399 t399-timer ]
[-maxcrbk value ]
Syntax Description
portid The portid is the PNNI physical port. Th e f o rm at is
[shelf.]slot[:subslot].port[:subport]. See also PNNI Format, page 6-4.
-t301 The T301 timer.
Range: 150–240 seconds
Default: 180
-t303 The T303 timer.
Range: 4–8 seconds
Default: 4
-t308 The T308 timer.
Range: 20–45 seconds
Default: 30