6-15
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Com m ands aesa_ping
Related Commands
dsppingatmaddr
Attributes
Examples
Ping the ATM end station with the address 47.00918100000000500ffde873.00500ffde873.0.
svcpop1.1.PXM.a > aesa_ping 47.00918100000000500ffde873.00500ffde873.01
Ping Got CLI message, index=0
PING:from PNNI - SOURCE ROUTE
DTL 1 :Number of (Node/port)elements 2
DTL 1:NODE 1::56:160:71:0:145::238:238:238:238:
Port 1:263168
DTL 1:NODE 2::56:160:71:0:145::15:253:232:115:
Port 2:0
Port List :no of ports = 1
Port ID 1:263168
svcpop1.1.PXM.a >
-trace Enable path trace during ping. This parameter only applies if -setupcall is enabled.
Possible values: yes or no
Default: no
-timeout Connection timeout for the ping. This parameter applies only if setupcall is enabled.
Range: 5120 seconds
Default: 5 seconds
-data If you enable data, the switch tran sf er s da ta then prints statistics at the en d of the
timeout.
Possible values: enable or disable
Default: disable
-interval The interval between the call setup of successive transmissions. This parameter
applies only if setupcall is enabled .
Range: 5120 seconds
Default: 5 seconds
Log: log State: active Privilege: SUPER_GP