Cisco Systems Cisco MGX 8850 cnfconsegep

7-28
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter7 SPVC and SVC Commands
cnfconsegep
cnfconsegep
Configure Connection Segment Endpoint
Configures a connection as a segment endpoint. When both VPI and VCI are present, the segment
endpoint is an F5 flow end point (f or VCCs) . When t he op ti on al VC I i s no t pr esen t, the se g ment e nd poi nt
is an F4 flow endpoint (for VPCs). Use this command only for established calls.
Note Before executing this command, be su r e c ontinuity checking is de-activated. If y o u leave i t o n ,
continuity check failure occurs for the connection . Use cnfconsegep in conjunction with connt race
for fault isolatio n.
Command(s) on Which Comm and Executes
PXM45
Syntax
cnfconsegep <portid>
< vpi >
[vci]
Syntax Description
Related Commands
cnfoamsegep, dspoamsegep, delconsegep, dspconsegep
Attributes
portid The portid represents the PNNI physical port and has the format
[shelf.]slot[:subslot].port[:subport]. See also PNNI Format, page 7-4.
vpi VPI of the connec ti on .
vci VCI of the connection.
Log: log State: active Privilege: GROUP1