3-81
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter3 Equipment and Resource Provisioning dsppart
dsppart
Display Resource Partition
Displays information about one resource partition. The displayed information is shown in the example.
Note The dsppart and dsprscprtn commands are identical. The name ‘dsprscprtn’ is consistent with th e
corresponding command in Relea se 1 of the MGX 8850 switch. You can use ei th er c ommand.
Note The connection count includes con tro l V C s w h en y ou execu t e dsppa rt on the CLI of a service
module. However, when you execute dspcd or dsppnport(s) on the CLI of the controller card, th e
display does not include control VCs.
The total number of connection s i n t h e d isp la y includes control VCs. The ty p es o f co ntrol VCs are
SSCOP, PNNI-RCC, and ILMI (if ILMI is en ab le d). To see the connection counts that do no t include
control VCs, use dsppnport.
Cards on Which This Command Runs
AXSM
Syntax
dsppart <ifNum> <partId>
Syntax Description
Related Commands
addpart, cnfpart, delpart, dspparts
Attributes
if_num Logical interface (port) number. For AXSM, th e r an g e i s 1 –60.
part_id Partition identifier in the range 1–5.
Log: no log State: active, standby Privilege: ANYUSER