5-79
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter5 PNNI Commands dsppnni-node
Restricted transit Display the flag that indicates w h et her transit is restricted across t his node.
This value can be set to off to secure the node, or to minimize traffic handled
by the node if it is of eithe r low -c apacity or high-criticalit y.
on: Calls can transit acro s s th is no d e .
off: Only calls terminating on end-systems supported by this node can access
this node.
Complex node Indicates whether this node is a complex node. A node at the lowest level
cannot be a complex node. Therefore , in t he current release, this field always
contains “off.”
on: This node is a complex node.
off:This node is not a complex node.
Branching restricted Indicates whether the node supports point-to-multipoint branching.
on: This node does not support point-to-multipoint branching.
off: This node supports point-to-multipoint branches.
Admin status Display the administrativ e st atus o f the nod e. You can disable or enabl e a node
by executing the cnfpnni-node command with appropriate parameters.
up: The logical PNNI node is enabled.
down:The logical PNNI node is disabled.
Operational status Display the operational status of the node. The software determines the
operational state, so you cannot configure it.
Non-transit for PGL
election Display whether transit is re str ict ed ac ro ss t hi s n od e. Th is valu e i s s et by th e
software and is not user-configurable.
on: Only calls that terminate o n th is node can access this node.
off: Calls can transit this node.
Node id For the c on s ti tu en ts of t he node ID, see the descrip t io n of addpnni-node or
cnfpnni-node. Before you change the node ID, you must disable the node by
entering cnfpnni-node -enable false. See description of cnfpnni-node.