3-32
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter3 Equipment and Resource Provisioning
cnfpart
cnfpart
Configure Resource Partition
Modifies a resource partition. A resource partition on an AXSM consists of minimum and maximum
percentages of bandwidth, a VPI/VCI range, and a minimum and maximum number of connections
available to a network control application. The current network controller is PNNI. Refer to the
description of addpart for information on resource partitions.
Note The cnfpart and cnfrscprtn commands are identical. The name ‘cnfrscprtn’ is consistent with th e
corresponding command in Relea se 1 of the MGX 8850 switch. You can use ei th er c ommand.
Cards on Which This Command Runs
AXSM
Syntax
cnfpart
-if <if>
-id <partionID>
-ctlr <controllerID>
-emin <egrMinBw>
-emax <egrMaxBw>
-imin <ingMinBw>
-imax <ingMaxBw>
-vpmin <minVpi>
-vpmax <maxVpi>
-vcmin <minVci>
-vcmax <maxVci>
-mincon <min connections>
-maxcon <max connections>
Note The maximum number of connections must be greater than 10.
Syntax Description
Note On a virtual trunk, the min_vpi and max_vpi must be the same.
-if Logical interface (port) num be r. For AXSM , th e r an g e i s 1–60.
This parameter is the sam e as the ifNum that appears in other comman ds.
-id Specifies the number of th e pa rtition in the range 1–5.
-ctlr Specifies the number of the controller in the range 1–20.
-emin Specifies the guaranteed percentage of egress bandwidth. Each unit of egrMinBw is
0.00001 of the total bandwidth on the por t. (An egrMinBw of 1000000 = 100%.) This
approach provides a hi gh level of granularity.