Cisco Systems Cisco MGX 8850 manual cnfport

3-34
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter3 Equipment and Resource Provisioning
cnfport
cnfport
Configure Port
Configures a logical port on a service module. The system does not display a confirmation upon
successful execution, so use dspport to check the changes.
Note You cannot use cnfport to change the guaranteed rate and maximum rate parameters if a resource
partition has been configured fo r th e i nt er fac e.
You can change the SCT ID if you first down the port by executing dnport, then executing cnfport.
After you change the SCT ID, execute upport to return the port to operation. Descriptions of dnport
and upport appear in the chapter, “Troubles hooting Commands.”
Cards on Which This Command Runs
AXSM
Syntax
cnfport
-if <ifNum>
[-min <guaranteedRate>]
[-max <maxrate>]
[-sct <sctID>]
Syntax Description
Note that this command uses the keyw ord (or com mand deli neator ) to ide ntify the param eter that follo ws
it. After you identify the lo gi cal p or t w ith t he ifNum parameter, each rema ining parameter is option al .
-if A logical port (interface) num ber. Only one logical port is allowed if the lin e operates
as a UNI or NNI. For the virtual network to netwo rk i nt erfa ce (VN NI), mult ipl e po rts
can exist on a line. For AXSM, the range 1–60.
-min Specifies the guaranteed rat e o n a l ogi cal port in cells/second. The cumul ative
guaranteed rate cannot exceed th e h ig h est valu e i n t h e f ollow in g ra nges :
OC48: 50–5651320 cps
OC12: 50–1412830 cps
OC3: 50–353207 cps
T3: 50–96000 (PLCP) or 104268 (ADM) cps
E3: 50–80000 cps