7-13
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter7 SPVC and SVC Commands addcon
Error Messages
The system can display error messages for the following reasons:
•Some of the traffic management parameters apply to specific service types (rt-VBR, for example).
If you type a parameter that do es not apply to a selected traffic ty pe , th e co nn ec tio n is rejected.
•Insufficient resources are available to a ccept the provisioning request.
•The type of card does not support a certain feature.
•The port cannot support SPVCs.
One of the following error messages appears if one of the preceding causes is true:
•“Port does not support requested serviceType”
•“lscr/lmcr not allowed to exceed l pc r (dcm p)”
•“rscr not allowed to exceed rpcr”
•“lpcr must be defined for cbr serviceType”
•“rpcr must be defined for cbr serviceType”
•“lpcr and lscr must be defined for vbr serviceType”
•“rpcr and rscr must be defined for vbr serviceType”
•“lpcr must be defined for abr/ubr serviceType”
•“rpcr must be defined for abr/ubr serviceType”
•“Requested rcdv is too low”
•“Requested rctd is too low”
•“Requested max cell loss r a ti o (c lr ) is t oo h ig h ”
•“Requested cell rate (lscr/ lp cr ) is t oo h ig h ”
•“Requested cell rate (rscr/rpcr) is too high”
Related Commands
cnfcon, cnfabr, delcon, dspcon, dspcons, dncon, upcon
Attributes
Example
Add the slave end of a VCC on logical port 1 with VPI=10, VCI=40, CBR service type. Note that the
system returns the slave end connection iden tifier in the hexadecimal NSAP format with the VP I.VCI at
the end. When you add the master endpoint of the connection, type –slave followed by this connection
identifier. You can do a copy and paste rather than typ in g th e w ho le s trin g .
MGX8850.AXSM.a >addcon 1 10 40 1 s
slave endpoint added successfully
slave endpoint id: 00000E1000001C008051B730FFFFFF010B180100.10.40
Log: log State: active Privilege: GROUP1