5-30
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter5 PNNI Commands
cnfpnni-node
Note In the current release, you must kee p the default values for -lowest , -complexNode, and
-branchingRestricted.
Caution Cisco factory-set defaults fo r a ddr ess p re fix e s a nd the pe er gro up I D share f iel d v al ue s wit h the ATM
address. If you change the peer group ID, you should change the corresponding fields in the ATM
address and node identifier. (See Figure 5-6 for the mapping between these addresses.)
-complexNode Specify whether this node is a complex node. The lowest-level node cannot
be a complex node.
on:This node is a complex node.
off:This node is not a complex node.
Default: off
Note This release does not support multiple peer groups, so this
parameter must remain off.
-branchingRestricted Specify whether the PNNI nod e a llow s p oi n t- to -m ultipoint branches.
on:This node does not allow point-to-multipoint branches.
off:This node allows point-to-multipoint branches.
Default: on
Note This release does not s up po rt b ranching, so this paramet er m u s t
remain on.