Cisco Systems Cisco MGX 8850 bootChange

2-12
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter2 Shelf Management Commands
bootChange
bootChange
Boot Change
Sets the boot IP address and gatewa y a ddr ess of the P XM45 ca rd . The boo t IP a ddr ess i s us ed onl y when
the PXM45 card boots up.
In the current release, the only parameters you should enter ar e “inet on ethernet (e)” and “gateway inet
(g).” The bootChange command presents one parameter at a time . Therefore, press the Return (or E nter)
key at each prompt except for these tw o. The example in this description shows the two fields where you
need to enter an IP address and th e fiel ds yo u ski p.
Note The boot IP address does no t get saved with saveallcnf.
Note Use the ipifconfig command to assign IP addr ess es fo r th e P XM4 5 an d th e s h el f.
Cards on Which This Command Runs
PXM45
Syntax
bootChange
Related Commands
none
Attributes
Log: log State: active Privilege: SERVICE_GP