Cisco Systems Cisco MGX 8850 cnfaddrreg

4-6
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter4 ILMI Commands
cnfaddrreg
cnfaddrreg
Configure Address Registration
This command lets you enable or disable ILMI address registration for a port. Before you can run
cnfaddrreg, the following must have occurred:
1. The applicable port must have been c re ate d by running the addpnport command.
2. The port must be downed by running the dnpnport command.
The cnfaddrreg command can also en ab le (or disable) the address registratio n fo r ba ck wa rd
compatibility.
The peer must support address registration, so you must confirm that address registration is enabled on
all three places.
Cards on Which This Command Runs
PXM45
Syntax
cnfaddrreg <portid> [{yes | no}]
Syntax Description
In addition to typing a port ID, you must also type either “yes” or “no.” The default is “yes.”
Related Commands
None
Attributes
Examples
Disable ILMI address registration on port 4:1.1:11.
Geneva.7.PXM45.a > cnfaddrreg 4:1.1:1 no
portid The portid is the PNNI ph ysi cal port. The format is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page 4-2.
yes Enable ILMI address registration on the port. The default is “yes” (enabled).
no Disable ILMI address registration on the port.
Log: log State: active Privilege: GROUP1