5-69
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter5 PNNI Commands dsppnni-link
dsppnni-link
Display PNNI Link Table–display the values of the PNNI link table.
The dsppnni-link command displays the parameters of all PNNI links.
•If you specify a node index and a port ID, the command displays information about that specific
PNNI link.
•If you specify only a node index, the display shows all PNNI links attached to tha t node.
•If you specify nothing, the command displays all links attached to all PNNI nodes in the network.
Cards on Which This Command Runs
PXM45
Syntax
dsppnni-link
[node-index [port-id]]
Syntax Description
Display Contents
The dsppnni-link command displays the address, link, and Hello packet information of each link. In a
multi-peer group, it also displays the upnode ATM address and node ID. For an explanation of upnode,
see the description of dsppnni-inducing-uplink.
Related Commands
dsppnni-link-selection
Attributes
node-index A system-generated value that corresponds t o a lo g ic al node in an MPG
hierarchy. For every PNNI node that you add through CWM or the
addpnni-node command, the system associ ate s th e nex t availa bl e i n tege r in
the range 1–10.
Note In the current release, the valu e of t he node-index is always 1.
Range: 1–10
portID The portid is the PNNI physical port. Th e f o rm at is
[shelf.]slot[:subslot].port[:subport]. See also PNNI Format, page 5-5.
Log: log State: active, standby Privilege: ANYUSER