8-12
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter8 Network Optimization Commands
dspload
dspload
Display Load—displays maximum channels and bandwidth and currently available channels and bandwidth on a
partition.
This command displays the configur ed maximum and guaratneed number of channels and the configured
maximum and guaranteed bandwidth on a partition on a logical interface. It also displays the currently
available number of channels and the currently available bandwidth on the partition.
This information can allow y ou to d et ermine the throughput requ ir e ments for a partition and th e a ctual
resource utilization.
The output shows the configured bandwidth for user connections of all service classes.
The display also shows the load cr eat ed by co n tr ol V C s. Th e control VCs are of three types: SS C OP,
PNNI-RCC, and ILMI (if ILMI is enabled). The bandwidth allocations for SSCOP and PNNI-RCC
control VCs are configurable (see cnfpnctlvc.) The bandwidth for an I L M I V C i s fixe d, as follows:
PCR=1000 cps; SCR=50cps; and MBS=1024 cells.
Cards on Which This Command Runs
AXSM
Syntax
dspload <ifNum> <partId>
Syntax Description
Related Commands
dsprscprtn, addcon, dspcons, dspcon, cnfcon
Attributes
ifNum The logical port number. The range for AXSM is 1–60.
partId The partition identifier. The range is 1–20. If necessary, use dsprscprtns to see the
existing partitions.
Log: no log State: active, standby Privilege: ANYUSER