5-96
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter5 PNNI Commands
dsppnni-ptse
PTSE ID The unique identifier of the PTSE. ptse-id is a 32bit number index
assigned by the PNNI node that cr ea ted the PTSE.
PTSE type The type of PTSE is an ASCII designated by the ATM forum PNNI
standard. Broad and narrow categories.
Nodal State Parameter Information
internal reachable ATM
addresses A list of reachable ATM addresses that are inside the peer group or
network.
exterior reachable ATM
addresses A list of reachable ATM addresses that are outside the network. The
current release does not support exterior addresses.
PTSE length The number of bytes in t he PTSE—a 16-bit number.
sequence The sequence of the PTSE—a 32-bit number.
checksum The checksum error-checking value. A 1 6- b it hex n umb er.
remaining lifetime The length of the remain in g lif et ime (in seconds). 32-bit nu m b er.
details for IG The flag that determines the level of deta ils fo r in f or m a ti on g roup
(IG) if the detail option is enab l ed (“true”).
Nodal Information Group Parameters
Note The current release does not suppor t the l ogical group node (LGN), pre ferred
peer group leader (P G L) , an d other items that pe r ta i n to t he levels of a
multi-peer group.
type The type of nodal information group (IG).
length The length of the nodal IG PTSE. A 16-bit number.
ATM address The upnode ATM address is a 20-byte, hexadecimal string. The
upnode is the node at the other end of the uplink. It is the
neighboring peer of the ancestor of th e node from which the uplink
originates.
priority The value of the priority parameter, an 8-bit number.
nodal flags The 8-bit nodal flags.
preferred PGL A 22-byte hex string. The current release does not support peer
group leader (PGL).
next higher level binding
information IG type The next higher level binding information IG type is an ASCII
string. The current release does not support higher level binding.