Cisco Systems Cisco MGX 8850 cnfpnportacc

6-33
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Com m ands cnfpnportacc
cnfpnportacc
Configure Port Access—associates an ATM filter set with a port.
The cnfpnportacc command lets you associate an ATM filter set with a port (after you create the filter
set with addfltset). You must specify at least one filter set if you u s e th is c om mand.
Cards on Which This Command Runs
PXM45
Syntax
cnfpnportacc <portid> [-in in-filter-name] [-out out-filter-name]
Syntax Description
Related Commands
delpnportacc, addfltset
Attributes
portid The portid is the PNNI physical port. Th e f o rm at is [shelf.]slot[:subslot].port[:subport]. See
also PNNI Format, page 6-4.
-in in-filter-name: the name of the filter set that applies to SETUP messages that arrive at the port.
-out out-filter-name: the n ame of the filter set that applies to S E TUP messages that leave the po rt .
Log: log State: active Privilege: GROUP1