Cisco Systems Cisco MGX 8850 cnfilmiproto

4-12
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter4 ILMI Commands
cnfilmiproto
cnfilmiproto
Configure ILMI Protocol
The cnfilmiproto command lets yo u co nfigu re h ow P N NI r ea cts to ILMI slave events. Use dsppnilmi
to confirm changes to the prefix.
Cards on Which This Command Runs
PXM45
Syntax
cnfilmiproto <portid> [-securelink {yes|no}] [-attachmentpoint {yes | no]
[-modlocalattrstd {yes | no]
Syntax Description
Related Commands
dsppnilmi
Attributes
portid The portid is the PNNI physical port. Th e f o rm at is
[shelf.]slot[:subslot].port[:subport]. See also PNNI Format, page 4-2.
-securelink Sets the flag securelink to make PNNI release th e call if it loses connection to the
ILMI slave.
no: do not enable the ILMI Secure link protocol.
yes: disable the ILMI Secure link protocol.
Default: yes
-attachmentpoint Sets the flag attachmentpoint to make PNNI release the call if t he slave I LM I
session sees changes in peer information, such as the system name or system ID.
no: do not enable the detection of loss of attachmentpoint protocol.
yes: Enable the detection of loss of attachmentpoint.
Default: yes
-modlocalattrs td Sets the flag modlocalattrstd to m ake PNNI release the call if th e slave ILMI sees
ATM layer (partition resource) changes, such as the VPI or VCI.
no: disable the ILMI standard p r oc ed ur e fo r m o di ficatio n o f lo cal ATM param.
yes: enable the ILMI standard procedure for modification of local ATM param.
Default: yes
Log: log State: active Privilege: GROUP1