5-99
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter5 PNNI Commands dsppnni-ptse
remote nodeid The node ID of the remote node. For a description of the node ID,
see the description for addpnni-node or cnfpnni-node.
remote port id The logical PNNI identifier o n t h e r em o te in te rface. For more
details, see PNNI Format.
Range: 1–2147483648
local port id The logical PNNI identifier on the local interface. For more details,
see PNNI Format.
Range: 1–2147483648
aggregation token See the description of the cnfpnni-intf command for a definition of
an aggregation token. The current release does not support link
aggregation.
Range: 1–32
Uplink IG Parameters
Note The current release does not support uplinks.
type The ASCII string that indicates the type of up link IG parameters.
length A 16-bit number.
flags A string of 8-bit flags.
remote higher level node id The PNNI node identifier assigned t o a PNNI node.
common pg id The peer group ID (of length level) that assigned to the PNNI
common PG. This peer group is the local peer group.
Default: Figure 5-1 shows the factory-set default.
local port id The logical PNNI identifier on the interface. For more details, see
PNNI Format.
Range: 1–2147483648
aggregation token R a nge: 1–2147483648.
upnode ATM address The ATM address of the PNNI uplink node. The upnode ATM
address is a 20-byte, hexadecimal string. The upnode is the node at
the other end of the uplink. It is the neig hb ori ng p eer o f t he an cest or
of the node from which the uplink originates.
Default: none