3-86
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter3 Equipment and Resource Provisioning
dspports
dspports
Display Ports
Displays general informat ion about all logical ports o n the card. On the AXSM, the i nformation consists
of the following for ea ch logical port:
•Logical port number (ifNum). On th e AX SM , for example, the range is 1–60.
•Physical line number in the f or ma t bay.port.
•Operation status—whether the port is up or down.
•The minimum guaranteed rate in cells per second.
•The maximum allowed rate for th e p or t in ce ll s pe r seco n d.
•The ID of the port-level SCT (see addport).
•The VPI number (applies only wh ere v ir tu al N NIs ar e avail ab le).
Cards on Which This Command Runs
AXSM
Syntax
dspports
Related Commands
addport, cnfport, delport, dspport
Attributes
Examples
Display the logical ports on the current AXSM. Note that if no SCT file had been specified for a
particular logical port (ifNum), the output gives a warning about the defau lt SCT file usage for that po rt.
See also the description for th e cnfcdsct command.
MGX8850.1.AXSM.a > dspports
ifNum Line Oper. Guaranteed Maximum sctID ifType VPI
Status Rate Rate (VNNI only)
----- ---- ------ ---------- --------- --------------------- ------ ---------
1 1.1 Up 10000 10000 4 UNI 0
2 1.2 Down 10000 10000 4 UNI 0
3 1.3 Down 10000 10000 4 VNNI 1
4 1.3 Down 10000 10000 0 !DefaultSCT used! VNNI 2 UNI 0
Log: no log State: active, standby Privilege: ANYUSER