Cisco Systems Cisco MGX 8850 dsppnport

6-87
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Com m ands dsppnport
dsppnport
Display PNNI Port—displays PNNI port information.
The dsppnport command shows dynamic, operational data rather than just the configuration data you
would see by executing dspport on a service module.
The total number of connections that the dsppnport shows does not include control VCs. The types of
control VCs are:
•Service-specific connection-oriented protocol (SSCOP)
•PNNI routing control channel (PNNI-RCC)
•Interim local management interface (ILMI) but only if ILMI is enabled
To see the connection counts that include con trol VCs, use the commands that operate on the CLI of the
service modules (dspln, dsppart or dsprscprtn, dspcd, or dspport).
Cards on Which This Command Runs
PXM45
Syntax
dsppnport <portid>
Syntax Description
Related Commands
dspnports, addpnport, delpnport
Attributes
portid The portid is the PNNI physical port. Th e f o rm at is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page 6-4.
Log: nolog State: active, standby Privilege: ANYU SE R