6-49
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Com m ands cnfsigdiag
-cldaddrmask The the atm-address-mask: Address mask for identifying valid b its of t he ca lled
NSAP address field (ff.ff.ff, for example). To match t his sel ect ion criterion, a failed
connect setup must have a called p ar ty a dd r ess val ue eq ua l t o th e c onfigured called
party address for all bits t hat are 1 in the specified mas k.
Default: NULL. NULL me an s th e rejected call matches the filte r cr ite ri a f o r any
called address in the rejected ca ll .
-clgaddrmask The atm-address-mask: Address mask for identifying valid bits of the calli ng N S A P
address field. (ff.ff.ff, for example). To match this selection criter ia, a faile d co n ne ct
setup must have a calling party address value equal to the configured calling party
address for all bits that a re 1 in th e s pe cifi ed m as k.
Default: NULL means the call match es the filter criteria for any calling address in the
rejected call.
-casttype Filtering by connection type. The types are point-to-point (p2p), point-to-multipoint
(p2mp)—currently not supported, or both (all)).
Default: all
-clrcause The clear-cause-code: Filters ATM signalin g cal l failures by the release caus e co d e
(a decimal number) as specified in the ATM Forum UNI 3.1 specification.
Default: 0, meaning t he cause code is not co ns i dered during filtering .
-connctgy Filters ATM signaling call failures by vi rt ua l circuit category (SPVC, SP V P, SVC,
SVP, or all of these circuit categories).
Default: all
-inport The portid: filters ATM signaling call failures based on the incoming port of the ca ll.
Default: 0, meaning t he incoming port is not c o nsi dered during filtering.
-outport The portid: filters ATM signaling call failures based on the outgoing port of the call.
Default: 0, meaning the outgoing port is not considered during filtering.
-maxrec The max-num-records: the maximum number of records collected f or a particular
signaling diagnostics filt er tabl e entr y . Whe n the maxi mum v alue i s reache d, th e older
records are deleted. If this fie ld is set to -1, the records are no t over w ri tt en . S et ti ng
this field to -1 increases memory usage for call failure records and can lead to
shortages of available system memory.
Range: –1 through 214783647
Default: 20
-scope The filtering scope choices are within the switch (int), on other switches (ext), or both
(all).
Default: all