9-37
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter9 Troubleshooting Commands cnfpnportloscallrel
cnfpnportloscallrel
Configure PNNI Port Loss of Signal Call Release
The cnfpnportloscallrel command lets you s hut o f f the s ta ndard de lay fo r r erout in g ca lls o n a p ort wh en
the system detects loss of signal (LOS) on a port.
When the system detects LOS on an N N I li n k, th e sw i tch d o es n ot i m med ia tely tear down the calls on
the link—in case the break i s m o men ta ry. By default, the system waits for th e S S C O P “no-response”
and T309 timers to tim e out before it releases ca lls on the broken link. T he default values for these timers
are 30 seconds and 10 seconds, respec tively. The system-level assumption (and therefore the d efault for
cnfpnportloscallrel) is to retain all the calls for a tempo rary loss of connectivity, but this can also have
the effect of delaying the rerouting of connections. The cnfpnportloscallrel command lets you direct
the system to reroute calls without delay on a particular port.
Cards on Which This Command Runs
PXM45
Syntax
cnfpnportloscallrel <portid> <yes | no>
Syntax Description
Related Commands
dsppnportloscallrel
Attributes
Example
Enable call release upon LOS for port 3:1.1:1, then confirm its status.
8850_NY.8.PXM.a > cnfpnportloscallrel 3:1.1:1 yes
8850_NY.8.PXM.a > dsppnportloscallrel 3:1.1:1
Call release on Los :enabled
portid The portid represents the PNNI logical port and has the format
[shelf.]slot[:subslot].port[:subport]. See also PNNI Format, page 9-3.
yes | no Specifies whether immediate call r ele ase is enabled upon LOS. To enable this
feature—to remove the standard reroute delay—type “yes.”
Default: no.
Log: log State: active Privilege: SUPER_GP