3-69
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter3 Equipment and Resource Provisioning dspcons
Cards on Which This Command Runs
PXM45, AXSM
PXM45 Syntax
dspcons[-port portid] [-vpi starting-vpi] [-vci starting vci]
[-state {fail|ais|abit|ok|down}] [-owner {master|slave}]
PXM45 Syntax Description
Related Commands
dspcon, addcon, cnfcon, delcon, dncon, upcon
PXM45 Attributes
AXSM Attributes
-port The port identifier (portid) in the format that the network cont r ol ler ut il ize s:
[shelf.]slot[:subslot].port[:subport]
Currently, the value for shelf is always 0 and therefore is not necessary.
-vpi The VPI of the connection that you would like to serve as the starting
connection in the display.
-vci The VPI of the connection that you would like to serve as the starting
connection in the display.
-state A specific connection state. The displa y shows only the connections with the
state you specify. Note t hat on t he PX M45, yo u mu st spe ll out th e enti re st ate
keyword. The keywords for specifying a state are
failed—only failed conne c ti on s
ais—connections with alarm indi catio n sig nal (AI S) set
abit—connections on which an A-bit error has occurred
ok—connections with no problems
down—connections that are administra tively d own b eca use a user has
executed dncon to down the connectio n
-owner Specifies connections where the l o cal en dp o in t is e ither master or slave.
Log: no log State: active, standby Privilege: ANYUSER
Log: no log State: active, standby Privilege: GROUP1