Cisco Systems Cisco MGX 8850 cnfserialif

2-31
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter2 Shelf Management Commands cnfserialif
cnfserialif
Configure Serial Interface
The cnfserialif command lets you change the data rate on a serial interface on the PXM45-UI-S3 back
card. The two types of serial p orts are the console port and the main te nance port. These ports provide
user-access for controllin g the switch. The default speed n a seri al interface is 9600 bits per second , but
higher speed terminals are frequently available.
Each port connects to a different type of terminal implementation. Refer to the Cisco MGX 8850 Routing
Switch Software Configuration Guide for a description of how to use these physical ports for switch
control.
Cards on Which This Command Executes
PXM45
Syntax
cnfserialif <port#> <speed>
Syntax Description
Related Commands
delserialif, dspserialif
Attributes
Example
Configure the console port to have a data rate of 19200 bits per second.
node19.8.PXM.a > cnfserialif 2 19200
port# Specifies the physical port:
•1=maintenance port.
•2=console port.
speed Specifies a data rate in bits per second. Valid entries are 1200, 2400, 4800, 9600,
19200, and 38400.
Log: no log State: active Privilege: SUPER_GP