Cisco Systems Cisco MGX 8850 cnfsigdiag

6-48
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Commands
cnfsigdiag
cnfsigdiag
Configure Signaling Diagnostic
The cnfsigdiag command lets you create a filter table for signaling diagnostics or disable signaling
diagnostics. Signaling diagnostics are disabled by default.
The ATM signaling di agnostics are tools for troubleshooting call failures in the network and should not
be enabled while the switch is oper at in g .
Cards on Which This Command Runs
PXM45
Syntax
cnfsigdiag {[enable | disable | index]}
[-cldaddr nsap-address]
[-clgaddr nsap-address]
[-cldaddrmask atm-address-mask]
[-clgaddrmask atm-address-mask]
[-casttype {all | p2p | p2mp}]
[-clrcause clear-cause-code]
[-connctgy {all | svc | svp | swvc | swvp}]
[-inport portid]
[-outport portid]
[-maxrec max-num-records ]
[-scope {all | ext | int}]
[-servctgy {all | cbr | rtvbr | nrtvbr | ubr | abr}]
[-status {active | inactive}]
Syntax Description
enable,
disable, or
index
Enable or disable sign aling diagnostics or c on figure an index.
Specify the diagnostics in dex number for the filter table an d enter the diagnostics
configuration mode . T he range for index is 1–50. If you do not specify an index, the
enable or disable condition globally applies to all signaling diagnostics.
Default: disable
-cldaddr The nsap-address is the filter for ATM signaling call failures agai ns t t hi s ca lle d
address.
Default: NULL
-clgaddr The nsap-address is the filter for ATM signaling call failures against thi s ca lling
address.
Default: NULL