Cisco Systems Cisco MGX 8850 cnfpnni-svcc-rcc-timer

5-41
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter5 PNNI Commands cnfpnni-svcc-rcc-timer
cnfpnni-svcc-rcc-timer
Configure PNNI Switched Virtual Connection Routing Control Channe l (SVCC-RCC) Timer—spe cify the par ameters
for any PNNI RCCs between logical nodes.
The current release does not support this command. The cnfpnni-svcc-rcc-timer command lets you
specify the initial PNNI SVCC-based variables for a network node. Logical group nodes (LGNs) use
SVCC-RCCs to exchange routing information.
Cards on Which This Command Runs
PXM45
Syntax
cnfpnni-svcc-rcc-timer <node-index>
[-initTime init-time]
[-retryTime retry-time]
[-callingIntegrityTime calling-integrity-time]
[-calledIntegrityTime called-integrity-time]
Syntax Description
node-index In the current release, the only suppo rted value for node-index 1. The node
index indicates the relative level o f the logical node within a multi-peer
group on the switch. The range is 1–10, and the lowest level is 1.
Range: 1–10
Default= 1
-initTime The numbe r of s e conds this node wai ts b ef ore it advertises its c h oi c e of
preferred SVCC to a neig hbor with a numerically lower ATM address. This
node does so after dete rmining that such an S V CC s h ou ld b e es ta bl is h ed .
Range: 1–10 seconds
Default= 10
-retryTime The number of seconds this node waits before it attempts to re-establi sh an
apparently necessary and viable SVCC-base d RCC that was unexpec tedly
torn down.
Range: 10–60 seconds
Default= 60