Cisco Systems Cisco MGX 8850 cnfcdvtdft

7-22
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter7 SPVC and SVC Commands
cnfcdvtdft
cnfcdvtdft
Configure Cell Delay Variation Tolerance Default
For all connections of a part ic ular ser vi ce t ype on a PNNI lo gi cal por t, cnfcdvtdft configures the defa ul t
number of microseconds for the cell delay variation tolerance (CDVT ). The direction is ingress. The new
configuration applies to new incoming calls but not existing calls. You can execute cnfcdvtdft whether
the port is in the provision in g s ta te (prior to addport on the service module) or administr atively up.
Cards on Which This Command Runs
PXM45
Syntax
cnfcdvtdft <portid> <service_category>
[microseconds]
Syntax Description
Related Commands
dspcdvtdft
Attributes
portid The portid represents the PNNI ph ysi cal p or t an d ha s th e format
[shelf.]slot[:subslot].port[:subport]. See also PNNI Format, page 7-4.
<service_category> Service type: cbr, rtvbr, nrtvbr, ubr, or abr.
micro seconds The number of microseconds for CDVT.
Range: 0–2147483647
Default= 250,000
Log: log State: active Privilege: GROUP1