4-8
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter4 ILMI Commands
cnfilmi
cnfilmi
Configure ILMI
The cnfilmi command lets you configure the card-level ILM I for th e A X S M . Ac tivatin g th e card-level
ILMI through cnfilmi requires a pre-existing logical por t ( see a ddport) and resource partition (see
addrscprtn or addpart). No response appears unless an error o ccu r s.
Note For network-level IL MI in relation to PNNI, run the PNNI-specific ILMI commands on the PXM45.
Cards on Which This Command Runs
AXSM
Syntax
cnfilmi <ifNum> -id <partitionID> -ilmi <ilmiEnable> -vpi <vpi> -vci <vci> -trap
<ilmiTrapEnable> -s <keepAliveInt> -t <pollingIntervalT491> -k <pollInctFact>
Syntax Description
Related Commands
dspilmi, dspilmis, dspilmicnt, clrilmicnt, dnilmi, upilmi
Attributes
ifNum Logical port number. On an AXSM, t he range is 1–60.
-id Partition ID in the range 1–5. (See description of addpart or addrscprtn for information
regarding resource partition ID.)
-ilmi Enable or disable ILMI. 1=enable. 2=disable.
-vpi VPI for the ILMI signaling co nn ec ti on . T he range is 0–255.
-vci VPI for the ILMI signalin g co nn ec tion. The range is 0–65535.
-trap Enable or disabl e ILMI trap. 1=enab le. 2=disable.
-sKeep alive interval. The range is 1–65535 seconds.
-tPolling interval for T491 in the range 0–65535 seconds.
-kPolling interval K in the range 0–65535 seconds.
Log: log State: active Privilege: GROUP1