9-160
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter9 Troubleshooting Commands
upport
upport
Up Port
The upport command returns a logica l p o rt to t he up state (or ups the port) so th e port can again carry
traffic. The upport command concludes possible re-configuration or troubleshooting steps. Before you
execute upport, you must have downed the port by executing dnport. Throughout the sequence of
downing and upping a port, the configuration for the port remains intact whether the logical port is a
UNI or an NNI.
The routes for connections vary by inter fa ce t yp e:
•After you re-enable an NNI port through upport, you c an not re tur n th e re-r oute d co nnec tion s to th e
upped port. The PXM45 routes connections over the trunk as needed.
•On a UNI, the connections co nt in ue to exist but remain in the faile d state until you enable the p o rt
by executing upport.
Cards on Which This Command Runs
AXSM
Syntax
upport <ifNum>
Syntax Description
Related Commands
dspport, dspports, dnport
Attributes
Example
Restore port 1 on the current card to operation.
MGX8850.1.AXSM.a > upport 1
ifNum A logical port (interface) nu mber. Only one logical port is allowed if the line operates
as a UNI or NNI. For the virtual network to netwo rk i nt erfa ce (VN NI), mult ipl e po rts
can exist on a line. For AXSM, the range 1–60.
Use dspports or dspport as needed to determine which port to bring up.
Log: log State: active Privilege: GROUP1