Cisco Systems Cisco MGX 8850 Revertive Behavior

9-83
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter9 Troubleshooting Commands dspclksrcs
clock source is the internal os cillator in either the free running mode or the hold-over mode: in this case,
the software omits this fina lvalidation attempt because no other cl ocks sour ces withi n a cloc k hie ra rchy
are available.
Revertive Behavior
For information on reve rt ive behavior, see the cnfclks rc description.
Cards on Which This Command Runs
PXM45
Syntax
dspclksrcs
Related Commands
cnfclksrc, delclksrc, dspclkalms
Attributes
Example
Display the clocks. The display s h ows tha t b o th th e pr im ar y an d se condary clocks are good. They ar e
sourced at lines 2 and 3 of the AXSM in slot 6. Also, the primary source is providing the active clock,
and the system is configured for revertive behavior. The primary and secondary clock reasons are okay.
pinnacle.7.PXM.a> dspclksrcs
Primary clock type: generic
Primary clock source: 6.2
Primary clock status: good
Primary clock reason: okay
Secondary clock type: generic
Secondary clock source: 6.3
Secondary clock status: good
Secondary clock reason: okay
Active clock: primary
source switchover mode: revertive
Display information about the clo ck s o u rce s. T his example shows a BITS clock for th e p r im ary s o urce
with revertive mode enable d.
pop20one.7.PXM.a > dspclksrcs
Primary clock type: bits t1
Primary clock source: 7.35
Primary clock status: ok
Primary clock reason: okay
Secondary clock type: generic
Secondary clock source: 9:1.1:1
Secondary clock status: ok
Secondary clock reason: okay
Active clock: primary
source switchover mode: revertive
Log: no log State: active, standby Privilege: ANYUSER