Cisco Systems Cisco MGX 8850 cnfclkparms

2-19
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter2 Shelf Management Commands cnfclkparms
cnfclkparms
Configure Clock Parameters—configure line characteristics for an E1 BITS clock
The cnfclkparms command lets you configure the signal type and cable type for E1 BITS sources. The
configuration applies to both (upper and lower) sources.
Note In the current release, you can spe cif y o nl y th e c able type.
Cards on Which This Command Runs
PXM45
Syntax
cnfclkparms <signal type> <cable type>
Syntax Description
Related Commands
None
Attributes
signal type Specifies whether the signa l type for the clock is data or a synchronization
signal. Enter a 1 for data or a 2 for synchronization.
cable type Specifies whether the cable is a tw is ted p ai r or a coaxial cable. Enter a 1
for twisted pair or 2 for coaxial. The default is 1.
Log: no log State: active Privilege: ANYUSER