3-98
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter3 Equipment and Resource Provisioning
dspsct
dspsct
Display SCT
Display the contents of a service class template (SCT) for either the egress or ingress direction. For
information on SCTs, see the cnfcdsct and addport description. Also, refer to the description of SCTs
in the Cisco MGX 8850 Switch Software Configuration Guide, Release 2.
With the dspsct command, you can specif y:
•Egress or ingress direction
•A particular SCT templa te
•A section within the SCT (see S y nt ax D esc ription for an explanation)
Note Currently, the system does not sup p or t cer ta in parameters in the servic e c las s templates
(SCTs), so you can specify them through addcon, cnfcon, or Cisco WAN Manager.
These parameters are (when applicable) PCR, SCR, and ICR.
Cards on Which This Command Runs
AXSM
AXSM Syntax
dspsct <SCT_section> <sctID> <egr | ing>
AXSM Syntax Description
Related Commands
cnfcdsct, dspcdsct
SCT_section A specific part of the SC T, as follows:
•bw for bandwidth
•gen for policing and CAC
•cosb
•vcThr for VC thresholds
•cosThr for COSB thresholds
sctID SCT identifier in the range 1–255.
egr | ing Specifies the direction to which the template applies. Enter the entire string “eng” or
“ing.”