3-29
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter3 Equipment and Resource Provisioning cnfln
cnfln
Configure Line
Configures a line on the current service m od ul e. U se cnfln after you have activated the lin e u sin g upln.
Note You cannot configure a line that currently has any configured virtual interfaces on it.
Cards on Which This Command Runs
AXSM
Note The syntax varies according to the line type, so each line type has a description.

Syntax for SONET Line

cnfln
-sonet <bay.line>
-slt <LineType>
-clk <clockSource>

Syntax Description (SONET)

All parameters are keyword driven. Therefore, the order that you enter them does not matter.
-sonet Identifies the ba y (1 o r 2) and t he number of the li ne in th e form at bay.line. The rang e
for line is from 1 to the highest numbered line on the back card. For the range of line
numbers on specific AXSM models, see Table 3 -1.
-slt A number that identifies the type of SONET line. The range for LineType is 16 and
have the following significance:
1 = sonetSts3c
2 = sonetStm1
3 = sonetSts12c
4 = sonetStm4
5 = sonetSts48c
6 = sonetSTM16
-clk Determines whether the transmit clock comes from the backplane (local timing) or
the receive clock on the line (looped timing). The value for clockSource can be 1 or 2:
1 = loop timing: the receive clock is re-directed on the back card to become the
transmit clock.
2 = local timing: (default) clo ck f r om th e backplane is the transmit cloc k.