Cisco Systems Cisco MGX 8850 cnfautocnf

4-7
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter4 ILMI Commands cnfautocnf
cnfautocnf
Configure Auto Configuration
The cnfautocnf command enables or disables ILMI auto configurati on for a port. To use this command,
the port must be added but administratively down (via dnpnnport).
With auto-configuration enabl ed , t he ILMI slave side starts IL M I au to co n fig ur at io n to negotiate the
ATM layer parameters with its peer while ports come up. With auto-configuration disabled, the ILMI
slave does not start ATM layer parameter-negotiation whi le ports come up. Instead, the ILMI s lave uses
the local configuration paramete rs. The default state for auto-con figu ra ti on i s en ab le d.
Cards on Which This Command Runs
PXM45
Syntax
cnfautocnf <portid> [yes | no ]
Syntax Description
Attributes
Examples
Enable ILMI auto-configuration on port 4:1.1:11.
Geneva.1.AXSM.a > cnfautocnf 4:1.1:1 no
portid The portid is the PNNI ph ysi cal port. The format is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page 4-2.
yes Enable ILMI automatic configuration on the port.
Default: yes
no Disable ILMI automatic configur at io n o n th e port.
Log: log State: active Privilege: GROUP1