Cisco Systems Cisco MGX 8850 - page 431

6-13
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter6 Logical Node, Port, and Signaling Com m ands addpnport
Example
Add a port with the ID 6:1.1:1. Use the dsppnports co m m a nd to see if 6:1.1:1 ap pe a r s in a li st of all
ports.(If many PNNI ports already existed, you could use the dsppnport command for 6:1.1:1) It
appears at the end of the list—after the entries for BITS clock ports in the format 7.x.
Note that the IF status and the Administrative status are both up. (The IF refers to the logical interface
on the service module—the slave side rather than the PNNI controller side.) That IF status and the
Administrative status are up indicate s that the addpart and addport commands have already been used
on the service module. If these comma nds had not been e xecut ed, IF and Admin w ould be “provisioning”
and “down,” respectively. For details on the con tent of the dsppnports command, see its description.
M8850_NY.7.PXM.a > addpnport 6:1.1:1
M8850_NY.7.PXM.a > dsppnports
Summary of total connections
(p2p=point to point,p2mp=point to multipoint,SpvcD=DAX spvc,SpvcR=Routed spvc)
Type #Svcc: #Svpc: #SpvcD: #SpvpD: #SpvcR: #SpvpR: #Total:
p2p: 0 0 0 0 0 0 0
p2mp: 0 0 0 0 0 0 0
Total= 0/50000
Summary of total configured SPVC endpoints
Type #SpvcR #SpvpR #SpvcD #SpvpD Total
p2p: 0 0 2 0 2
p2mp: 0 0 0 0 0
Total=2
Per-port status summary
PortId LogicalId IF status Admin status ILMI state #Conns
7.35 17251107 up up NotApplicable 0
7.36 17251108 up up NotApplicable 0
7.37 17251109 up up NotApplicable 0
7.38 17251110 up up NotApplicable 0
1:2.1:1 16848897 up up UpAndNormal 0
2:2.2:1 16914433 provisioning up NotApplicable 0
3:1.1:1 16979969 down up Disable 0
3:1.2:2 0 provisioning down NotApplicable 0
6:1.1:1 17176577 up up Disable 0
M8850_NY.7.PXM.a >