[Network parameter] of GX Developer
(1) Network parameter
|
| Setting | |
Item | Set value | necessity at | |
GOT | |||
|
| ||
|
| connection | |
Network type | Ethernet (fixed) |
| |
|
|
| |
Starting I/O No.*1 | 0000H |
| |
Network No.*2 | 1 |
| |
Group No. | 0 (fixed) |
| |
|
|
| |
Station No.*3 | 2 |
| |
Mode | Online (fixed) |
| |
|
|
| |
Operation setting | Refer to (2) |
|
Initial settings
Open settings
Router relay parameter
Station
(Use default value)
FTP Parameters
Interrupt settings
Redundant settings*4
Routing Parameters | Refer to (3) |
: Necessary 
: As necessary 
: Not necessary
*1 When using Q170MCPU, set the start I/O to 0070H.
*2 Specify the same network No. as that of the GOT.
*3 Do not set the same station No. as that of the GOT.
*4 Set when using Ethernet module in a redundant QnPRHCPU system.
(2) Operation setting
|
| Setting | |
Item | Set value | necessity at | |
GOT | |||
|
| ||
|
| connection | |
Communication data code*1 | (Use default value) |
| |
IP address | 192.168.0.19 |
| |
|
|
| |
Initial timing*1 |
|
| |
Send frame setting |
|
| |
| (Use default value) |
| |
Enable Write at RUN time*1 |
| ||
|
|
TCP Existence confirmation setting
: Necessary 
: As necessary 
: Not necessary
*1 Because port No. 5001 is fixed, these items operate at the following setting without relations to the setting given here.
• Communication | : [Binary code] |
date code |
|
• Initial timing | : "Always wait for OPEN" |
| (Communication is applicable while |
| stopping the PLC CPU.) |
• Enable Write at | : [Enable Write at RUN time] (Writing |
RUN time | Data is applicable while running the |
| PLC CPU.) |
POINT
When changing the network parameter
After writing the network parameter to the PLC CPU, operate the PLC CPU ether turning OFF and then ON or resetting.
1
PREPARATORYFORPROCEDURESMONITORING 2
RANGESETBE
DEVICE CANTHAT 3
RANGEACCESS MONITORINGFOR 4
MONITORTOREDUNTANTSYSTEM HOW 5
CONNECTIONBUS 6
DIRECTTOCONNECTIONCPU 7
LINKCOMPUTER CONNECTION 8
ETHERNETCONNECTION
8. ETHERNET CONNECTION | 8 - 25 |
8.4 PLC Side Setting |
|