Setting item
This section describes the setting items of the Manufacturer, Controller Type, Driver and I/F. When using the channel No.2 to No.4, put a check mark at [Use CH*].
Item | Description | |
Use CH* | Select this item when setting the channel No.2 to No.4. | |
Manufacturer | Select the manufacturer of the equipment to be connected to the GOT. | |
Type | Select the type of the equipment to be connected to the GOT. For the settings, refer to the following. | |
| ||
I/F | Select the interface of the GOT to which the equipment is connected.For the settings, refer to the following. | |
| ||
Driver | Select the communication driver to be written to the GOT. For the settings, refer to the following. | |
| ||
Detail Setting | Make settings for the transmission speed and data length of the communication driver. | |
Refer to each chapter of the equipment to be connected to the GOT. | ||
|
(1)Setting [Driver]
The displayed items for a driver differ according to the settings [Manufacturer], [Controller Type] and [I/F]. When the driver to be set is not displayed, confirm if [Manufacturer], [Controller Type] and [I/F] are correct. For the settings, refer to the following.
[Setting the communication interface] section in each chapter
1
PREPARATORYFORPROCEDURESMONITORING 2
RANGESETBE
DEVICE CANTHAT 3
RANGEACCESS MONITORINGFOR 4
MONITORTOREDUNTANTSYSTEM HOW 5
CONNECTIONBUS 6
DIRECTTOCONNECTIONCPU 7
LINKCOMPUTER CONNECTION 8
ETHERNETCONNECTION
1. PREPARATORY PROCEDURES FOR MONITORING | 1 - 5 |
1.1 Setting the Communication Interface |
|