Router relay parameter
E-mail settings
8.4.7Connecting to Ethernet module (FX Series)

This section describes the settings of the GOT and Ethernet module (FX Series) in the following case of the system configuration.

POINT

Ethernet module (FX Series)

For details of the Ethernet module (FX Series), refer to the following manual.

FX3U-ENET User's manual FX3U-ENET-ADP User's manual

System configuration

■ [Controller Setting] and [Ethernet] of GT

Designer3

<GOT>

(The settings other than the following are set to the default)

PLC No.

: 1

IP address

: 192.168.0.18

Port No.

: 5019

Communication : TCP (fixed) format

<Ethernet module> (The settings other than the following are set to the default)

Network No.

: 1 (virtual)*1

PC No.

: 2 (virtual)*1

IP address

: 192.168.0.19

Port No.

: 5551

Communication : TCP (fixed) format

■ Ethernet parameter settings of FX Configurator-EN

*1 These setting items do not exist at the PLC side. However, the virtual values must be set on the GOT side.

■ [Controller Setting] and [Ethernet] of GT Designer3

Ethernet parameter settings of FX Configurator-EN

(1)Ethernet settings

Set the Ethernet parameter with FX Configurator-EN. For using FX Configurator-EN, install GX Developer Ver. 8.25B or later on the personal computer.

For details on FX Configurator-EN, refer to the following manual.

FX Configurator-EN Operation manual

Item

Setting

Setting

(with GOT connected)

 

 

Module

Module 0*1

 

Operational settings

Refer to (2)

 

 

 

 

Initial settings

(Use default value.)

 

 

 

 

Open settings

Refer to (3)

 

(Use default value.)

:Required :Set if necessary :Not required *1 Set the number of the Ethernet module.

8 - 38

8. ETHERNET CONNECTION

 

8.4 PLC Side Setting