Mitsubishi Electronics GOT1000 manual 566

(b) GT15, GT12

Item	Description	Range
GOT NET No.	Set the network No. of the GOT.	1 to 239
	(Default: 1)
GOT PLC No.	Set the station No. of the GOT.	1 to 64
	(Default: 1)
GOT IP	Set the IP address of the GOT.	0.0.0.0 to
Address	(Default: 192.168.0.18)	255.255.255.255
	Set the subnet mask for the sub
	network.(Only for connection via
Subnet Mask	router)	0.0.0.0 to
	If the sub network is not used, the	255.255.255.255
	default value is set.
	(Default: 255.255.255.0)
	Set the router address of the
Default	default gateway where the GOT is	0.0.0.0 to
	connected.(Only for connection via
Gateway		255.255.255.255
	router)
	(Default: 0.0.0.0)
		1024 to 5010 to
Ethernet	Set the GOT port No. for Ethernet	5014 to 65534
Download Port	download.	(Except for 5011,
No.	(Default: 5014)	5012, 5013 and
		49153)
	Set the GOT port No. for the	1024 to 5010 to
GOT		5014 to 65534
	connection with the Ethernet
Communication		(Except for 5011,
Port No.	module.	5012, 5013 and
	(Default: 5001)
		49153)
	Set the number of retries to be
	performed when a communication
	timeout occurs.
Retry	When receiving no response after	0 to 5times
	retries, the communication times
	out.
	(Default: 3times)
	Specify the time period from the
Startup Time	GOT startup until GOT starts the	3 to 255sec
	communication with the PLC CPU.
	(Default: 3sec)
	Set the time period for a
Timeout Time	communication to time out.	3 to 90sec
	(Default: 3sec)
	Set the delay time for reducing the
Delay Time	load of the network/destination	0 to 10000
	PLC.	( 10ms)
	(Default: 0ms)

POINT

(1)Communication interface setting by Utility The communication interface setting can be changed on the Utility's [Communication Settings] after writing [Communication Settings] of project data.

For details on the Utility, refer to the following manual.

GT User's Manual

(2)Precedence in communication settings

When settings are made by GT Designer3 or the Utility, the latest setting is effective.

18 - 12	18. CNC CONNECTION
	18.4 GOT Side Settings