1016
Marker Function
Measure at Marker
This key and all the keys in this menu only appear with the N6141A or W6141A application or Option
EMC installed and licensed.
Measure at Marker
When this key is pressed, the test set executes one Measure at Marker function and then returns. Measure
at Marker goes to the frequency of the selected marker and takes a reading with each of the three
detectors selected in the Detectors menu, using the dwell times specified there, then displays the readings
in a window on the display, using the current Y-Axis Unit.
When the Measure at Marker is complete, the test set restores all settings to their pre-Measure-at-Marker
values and normal sweeps resume.
Backwards Compatibility SCPI :CALCulate:MARKer[1]|2|3|4:X:STOP
(This legacy command was used to control the Delta marker in Delta
Pair/Band Pair mode, and is aliased to the new command. For compatibility.
Note that if you were using the old command for Band Power measurements it
will work just fine.)
Initial S/W Revision Prior to A.02.00
Key Path Marker Function
Dependencies The Measure at Marker menu is not available in Spectrogram.
Initial S/W Revision A.02.00
Key Path Marker Function, Measure at Marker
Remote Command :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:FUNCti on:
MAMarker?
Example :CALC:MARK2:FUNC:MAM?
Performs a Measure at Marker function at Marker 2’s current frequency and,
when completed, returns the results of the measure at marker window in a
query