1175
Source (Internal)
Pressing this key changes the current view to the Waveform Management View.
Load Segment To ARB Memory
Allows you to load the selected file into ARB memory. On the front panel you select the file for loading to the ARB
memory by highlighting the desired file in the list. Using the SCPI command, you specify the file name on the
HDD.
“NVWFM” (none-volatile storage) MSUS (Mass Storage Unit Specifier) is supported in the memory subsystem
because the ARB memory cannot be accessed directly. Therefore, files must be downloaded to the instrument hard
disk and then loaded into the ARB memory. “NVWFM” MSUS will be mapped to the default directory
D:\NVARB. The SCPI command supports using either “NVWFM” MSUS or specifying a full path. For more
information, see “Memory Subsystem (Remote Command Only)” on page 1260.
If a file of the same name already exists within ARB memory, it is overwritten. If you wish to load two segments of
the same name, you must rename one of the segments before loading it into ARB memory. To rename a segment,
you can either use Windows File Explorer, or the :MMEMory:COPY command.
Key Path: Source, Modulation Setup, ARB, Select Waveform
Initial S/W Revision: A.05.00
Key Path: Source, Modulation Setup, ARB, Select Waveform, Segments on Hard
Disk
Remote Command: :SOURce:RADio:ARB:LOAD <string>
Example: SOUR:RAD:ARB:LOAD “D:\NVARB\testwaveform.bin”
or
SOUR:RAD:ARB:LOAD “NVWFM:testwaveform.bin”