943
Input/Output
Insert Point Below
Inserts a point below the current point. The new point is a copy of the current point and becomes the
current point. The new point is not yet entered into the underlying table, and the data in the row is
displayed in light gray.
Delete Point
Deletes the currently-selected point, whether or not that point is being edited, and selects the Navigate
functionality. The point following the currently-selected point (or the point preceding if there is none)
will be selected.
Delete Correction
Deletes the correction values for this set. When this key is pressed a prompt is placed on the screen that
says “Please press Enter or OK key to delete correction. Press ESC or Cancel to close this dialog.” The
deletion is only performed if you press OK or Enter.
Apply Corrections
Applies amplitude corrections which are marked as ON to the measured data. If this is set to OFF, then
no amplitude correction sets will be used, regardless of their individual on/off settings. If set to ON, the
Notes: There is no value readback on the key.
Min: –1000 dB
Max: 1000 dB
Initial S/W Revision: A.02.00
Key Path: Input/Output, Corrections, Edit
Initial S/W Revision: A.02.00
Key Path: Input/Output, Corrections, Edit
Initial S/W Revision: A.02.00
Key Path: Input/Output, Corrections
Remote Command: [:SENSe]:CORRection:CSET[1]|2|3|4|5|6:DELete
Example: CORR:CSET:DEL
CORR:CSET1:DEL
CORR:CSET4:DEL
Notes: Pressing this key when no corrections are present is accepted without error.
Initial S/W Revision: A.02.00