1252
Source (Internal)
step is setup, the value entered run through several levels of validation.
Step Configuration of Frequency/Channel Number parameter list (Remote Command Only)
This SCPI command is to configure “Frequency” or “Channel Number” parameter array of the whole List
Sequencer at one time. The number of array is same as step number defined in “Number of Steps” on page 1221
Number of Steps. As a step is setup, the value entered run through several levels of validation.
Remote Command: :SOURce:LIST:SETup:RADio:BAND:LINK <enum>, <enum>,
<enum>, …
:SOURce:LIST:SETup:RADio:BAND:LINK?
Example: SOUR:LIST:SET:RAD:BAND:LINK DOWN,UP,UP
SOUR:LIST:SET:RAD:BAND:LINK?
Notes: The command is to setup below parameter array of whole list sequence.
Radio Band Link <enum> - specifies the radio band link direction for the
step. For details of the valid link types, see “Radio Band Link” on page 1240.
If input parameter number exceeds the step number defined by Number of
Steps then generate error ", and only those parametes whose index number
falls in number of steps will be updated.
Remote Command Notes: DOWN|UP
Dependencies: The range is 1 to 1000 which is determined by the number of steps you have
configured. For details see “Number of Steps” on page 1221.
Initial S/W Revision: A.09.40
Remote Command: :SOURce:LIST:SETup:CNFRequency <double>, <double>,
<double>, …
:SOURce:LIST:SETup:CNFRequency?
Example: SOUR:LIST:SET:CNFR 1GHz,100MHz,100MHz
SOUR:LIST:SET:CNFR?
SOUR:LIST:SET:CNFR 124,124,124
SOUR:LIST:SET:CNFR?