1218
Source (Internal)
PM Deviation
Allows you to set the phase modulation deviation.
PM Rate
Allows you to set the internal phase modulation rate.
Multiport Adapter Output Port Amplitude Correction Configuration Validation (Remote Command
Only)
This command is used to validate MPA TX port amplitude correction for Source MXG Mode.
Key Path: Source, Modulation Setup, PM
Remote Command: :SOURce:PM[:DEViation]
:SOURce:PM[:DEViation]?
Example: SOUR:PM 1.00 rad
Preset: 0.1 rad
Min: 0.1 rad
Max: 20.0 rad
Initial S/W Revision: A.05.00
Key Path: Source, Modulation Setup, PM
Remote Command: :SOURce:PM:INTernal:FREQuency
:SOURce:PM:INTernal:FREQuency?
Example: SOUR:PM:INT:FREQ 40.0 Hz
Preset: 400.0 Hz
Min: 10 Hz
Max: 40 kHz
Initial S/W Revision: A.05.00
Key Path: Remote Command Only
Remote Command: :SOURce:RADio:MPADapter:CORRection:ERRor?
Example: SOUR:RAD:MPAD:CORR:ERR?