Agilent Technologies U9072A cdma-2000 Offset Detector Selection Selects the detector mode for the offsets.

563
Spectrum Emission Mask Measurement
Trace/Detector
Offset Detector Selection
Selects the detector mode for the offsets.
Offset Detector Auto
Sets the detector to the default detection mode for the offsets. This mode is dependent upon the current
signal conditions of the offsets.
Key Path: Trace/Detector
Mode: WCDMA, C2K, WIMAX OFDMA, TD-SCDMA, 1xEVDO, LTE, LTETDD,
WLAN
Remote Command: [:SENSe]:SEMask:DETector:OFFSet[:FUNCtion]
AVERage|NEGative|NORMal|POSitive|SAMPle
[:SENSe]:SEMask:DETector:OFFSet[:FUNCtion]?
Example: SEM:DET:OFFS AVER
SEM:DET:OFFS?
Notes: When you manually select a detector (instead of selecting Auto), that detector
is used regardless of other analyzer settings.
Note: This detector setting has effects all offsets. There is not a per trace
detector.
You must be in the mode that includes SEM measurement to use this
command. Use :INSTrument:SELect to set the mode.
Couplings: See Couplings in the Trace Type section.
Preset: POSitive
State Saved: Saved in instrument state.
Range: Normal|Average|Peak|Sample|Negative Peak
Initial S/W Revision: Prior to A.02.00
Modified at S/W Revision: A.02.00, A.03.00
Key Path: Trace/Detector
Mode: WCDMA, C2K, WIMAX OFDMA, TD-SCDMA, 1xEVDO, LTE, LTETDD,
WLAN
Remote Command: [:SENSe]:SEMask:DETector:OFFSet:AUTO ON|OFF|1|0
[:SENSe]:SEMask:DETector:OFFSet:AUTO?
Example: SEM:DET:OFFS:AUTO OFF
SEM:DET:OFFS:AUTO?